Our products

These mounts are made from extruded aluminum section as shown in the diagrams. The engine sits in its own cradle which may have to be opened up to take the crankcase and then drilled and tapped for the mounting bolts. Several mounts are available for PICCO & K & B engines already machined and tapped. Mounts are available to fit between 4 & 5" rails. Inserts only are also available."

OCTURA hummdinger 4" wide engine mount with deep cradle, fits engines 3.5cc to between 4" stringers.

Special order only from manufacturer."

Octura V-65 engine mount insert cradle only

The OCTURA V-90 mount is a well made and sturdy mount which gives excellent support for your 11 to 15cc engines crankcase. Your engine sits in a cradle which is then supported with side bearers and their noise suppression rubbers. The mount is made to fit between 5 bearers.
Engine pads need to be adjusted, drilled and tapped for engine being used. Picture shows both V90 & V65 units
The V-65 has now been discontinued by OCTURA

Aeromarine OPS 21 Engine mount

Aeromarine engine mount pre drilled for OS46 motor to fit between 5" stringers

Aeromarine K&B 67 engine mount for 5" stringers

Aeromarine engine mount pre drilled for the CMB910/101 engine with 6 rubbers to fit between 5" bearers

SPDUM-001-S Universal STD. Mount The Speedmaster enginge mount is fully adjustable for engines from 6.5cc up to 15cc. It comes with sets of different thickness spacers to enable all engines to fit between 4" or 5" stringers.

SPDUM-002-O 7.5cc to 15cc Universal Offset Mount for monos where you need to get the engine as low as possible.

Engine mount rubbers 5/8" x 5/8" for Octura & Aeromarine mounts with 1/4"-20 threads male & female ends

£3.25 each"

Heavy duty male/female bobbin 1" x 3/4" as used in the BHHAnson mount and many of the American engine mounts with unc. threads.  A very strong bobbin ideal for petrol engine mounts. Complete with stainless steel nut, washers and bolt."

Rubber bobbin 15mm x 15mm male/female with 4mm stud and cap bolt complete with stainless steel nut and washers

Small engine mount bobbins 15mm x 15mm with 5mm studs, complete with s/s nuts and washers.

Large engine mount rubber bobbins 20mm x 15mm with 6mm male and female ends. comes with S/steel nut, bolt & washers.

Large engine mount bobbins also used in rubber couplings. 20mm x 15mm, with 6mm studs and s/s nuts & lock washers.

Discontinued 20mm x 15mm Engine mount rubber bobbins with 5mm male and female ends, complete with s/s nut, washers and bolt.