Our products

Zenoah crankcase complete with bearings and seals for PUM engines

Brand new unused RCMK clutch fits Zenoah and RCMK engines 260 to 300.

Pulley wheel to replace the cord pullstart on Zenoah and similar engines for use with starter belt & electric starter.

The Zenoah G260 Marine is a powerfull and reliable petrol engine straight out of the box and ready to go. Fitted with a twin needle Walbro 644 carburettor its performance is quite outstanding for a petrol engine.

Zenoah 300PUM 29.5cc NEW with 36mm bore and the 1mm stroker crankshaft giving this engine just over 5 bhp. Comes with the 1048 big bore carb, 4 transfer port with much better port timings and a higher compression and the EZ pullstarter to make starting much easier and quicker.

PRICE REDUCTION.<
ZENOAH 320PUM; . This latest engine has a new crankshaft/connecting rod combination, two bearings on the flywheel side and a new output side seal. It is the latest upgraded version with the stronger crankshaft assembly. A very powerfull engine with everything you would expect from Zenoah. Engine is fitted with electonic ignition, a big bore 1048 carb and the EZ pullstart for easier starting

Genuine Zenoah EZ pullstart. A much easier to use pullstart than the standard recoil drive dog one fitted to marine engines. Comes with all parts required to easily fit, Complete instructions sheet included.

Exhaust flange gasket

Spare 3.5mm x 22mm i.d. Orange silicone "O" rings to fit all of the the 22mm watercooled headers plus tuned pipes..

BHHANSON 22mm I.D. cooling ring to give extra cooling to the aluminum manifold, complete with brass water nipples and sealing "O" rings. 

Pro Boat twin inlet/outlet water pump and bracket for Petrol engines such as the Zenoah, RCMK etc.

Dubro Hi Flow large fuel filter for petrol or glow

Big Bore Walbro 643 carb fitted with primer a bulb. Bored out and bell mouthed the same as the 257 carb, giving a smooth flow of air across the fuel jets thus increasing the delivery of fuel air mixture to the engine. .

Big bore walbro WT-257-1 carburettor which has been modified by Hanson, having been bored out to 13.4mm with the inlet side profiled to obtain a smooth gas flow and without the choke butterfly or primer bulb. Instant exra power to your engine. Comes with new mounting bolts

S/Steel 90deg. header extra extra wide, 90mm to outside of bend

Standard Walbro 644 twin needle carb with priming bulb and without choke which gives a better intake of air.

Walboro 257 standard big bore carb.

320 Cylinder base gasket

320 Crankshaft bearing

320 Crankshaft sealed bearing

Zenoah piston gudgeon pin for 260 engines

Pulley wheel & Collet coupling 1/4" for belt starting of Zenoah, Sikk, RCMK etc. Allows you to use a belt start but retain the pullstart

Genuine Aeromarine coupling. Not a Copy. This coupling is specially designed to fit on the tapered crankshaft of the Zenoah Engines and similar engines and is supplied with a ROUND insert for 1/4 inch cable

AEROMARINE 3 part S/s Zenoah flexi shaft collet coupling for 1/4"
SQUARED cable. Supplied with squared insert for squared ended cable.